• My Account
    • ИконкаBoats in 3D

    • Your shopping cart is empty!

    Manual


    OPERATING MANUAL
    Inflatable boats (motor, rowing) BOATHOUSE
     
    Made under the supervision of the Inspectorate 
    of the register of Shipping of Ukraine
    Certificate of the Register of Shipping of Ukraine № SVP-224-3-39-18
    Model__________________________________________________
     
    Length, m ________ Width, m___________ Boart height, m 0,240
     (the largest) (the largest) (on the model)
     
    Maximum load _____kg Permissible power of the main engine  4,4(6)  kW (hp)
       
       HEREBY CONSIDERED in respect of the above vessel in accordance with the Rules for the Classification and Construction of Small Vessels the following:
    The vessel was built under the technical supervision of the Register of Shipping of Ukraine in accordance with the project approved by the letter 
    № 212. 1.705-2141 dated 14.08.2012р.  on a class with the symbol “КЕ             1    P35 Т2      N 2/round/prog”. 
     
     This guide will help you use your catamaran safely and with pleasure. The manual provides detailed information about the catamaran, its standard and optional equipment, as well as instructions for operation and maintenance. Read the manual carefully before using the catamaran.
     
       Preparation for operation 
    • Clear the area where you will place the boat from stones, branches and other sharp objects.
    • Take the boat out of the bag, place it on the prepared place.
    • Push the valve and turn it to the right so that it is in the uppermost position.
    • Connect the fur pump adapter to the valve.
    • Inflate the cylinder compartments with a bellows pump or electric pump to a nominal pressure of approx. 0.10 kgf / cm2 (when filling the boat with air, make sure that the hose is in the correct position, which should not bend).
    • Start filling from any compartment. Fill the first compartment before it takes shape. Fill the second compartment to the nominal pressure (when further pumping with a fur pump becomes more difficult). The pressure in the first compartment due to the movement of the partition is equal to the pressure in the second compartment.
    • Install the seat in the mount on the payloads.
    • Place the deck on the bottom of the boat under the clamps on the cylinders.
    • Inflate each compartment to a pressure of 0.25-0.3 kgf / cm2 with a mechanical pump or boat compressor.
    • Disconnect the adapter, close the valve with plugs.
    • Insert the oars into the cochet.
    • If optional equipment is installed.
    • Having completely assembled the catamaran - take it by the carrying handles and move the catamaran into the water (the stern part should be in the water, the bow - on the shore).
    • Install the engine.
    • After operation, the following steps must be taken:
    • Remove the engine.
    • Remove the catamaran from the water to the prepared place (without branches, stones, glass, etc ..).
    • Remove all additional equipment (awning, rod holders, oars, etc.) and allow the catamaran to dry, then wipe with a dry cloth.
    • Then you need to start inflating the catamaran from any cylinder: at the same time on all airtight compartments of one cylinder unscrew the lids and open the valve. Go to the other side of the catamaran and raise it so that the balloon begins to descend and go under the bottom of the catamaran.
    • As soon as the transom and frames touch the ground - the catamaran is lowered and the residual air is pumped out of the sealed compartments of the cylinder by an electric pump. 
    • Then you need to pull out the bottom and perform the same procedure with another cylinder. 
    • At the end you need to wipe the catamaran again with a dry cloth (remove sand, algae, water residue) and turn it to the middle of the stern and bow. Tie with a rope and put on the packing case.
       Warning: Do not use compressed air devices (automatic air compressor for inflating tires) to inflate your boat. Excessive pressure can cause the cylinder or baffle to rupture. 
    Warning! Operation of the boat at air pressure in onboard compartments which considerably exceeds nominal, leads to reduction of expiration date of your boat. When the boat is very hot in the sun, it is recommended to reduce the pressure to 0.25 kgf / cm2. When the boat is lowered into cold water, the pressure in the boat's cylinders will decrease, so they must be pumped to a pressure of 0.25-0.3 kgf / cm2.
    Operation of a badly inflated boat is unacceptable! 
    Sand is not allowed to enter the valves and nests of cochets. 
    Use catamaran components and equipment only for their intended purpose. Video instructions for operation on the site boathouse.ua
     
       Rules for cleaning, drying, storage and maintenance your catamaran in working order and maintenance:
    1. After swimming in sea water, be sure to rinse the cylinders, frame, deck with fresh water (preferably with a soap solution). 
    2. At the end of the season, the boat must be prepared for winter storage. Clean all parts from dirt, sand, etc. using a piece of absorbent fabric. Warning! Never use oil, petrol, acetone, kerosene, paraffin or similar solvents or chemicals. Before long-term storage, dry the catamaran completely. 
    3. The valves must be closed.
    4. Treat the ends of the frames and transom with antiseptic impregnation for wood or varnish.
    5. Do not allow water to get inside the catamaran cylinders. If gasoline or oil gets on the surface of the catamaran, it is recommended to wash the contaminated area with soapy water.
    6. The main condition for long-term catamaran service is proper care. Do not allow excessive pressure rise in the cylinders when heated in the sun.
    7. If damage is detected, repairs must be made. If conditions allow, it is better to store the catamaran in a dry place 
    8. Minor repairs (puncture, cut) you can do yourself, using a repair kit. Complex repairs associated with damage to the cylinder, partitions and seams, do not do it yourself. In this case it is necessary to address to our representative.
    9. When packing a catamaran, make sure that the individual items do not deform each other. Store the packed catamaran in a dry place, protected from direct sunlight. Do not place heavy objects on top of a packed catamaran. Attentive attitude and good service will extend the life of your catamaran.
       Safety requirements:
    1. Do not use the catamaran in poor conditions, such as low visibility, at night, in fog or rain.
    2. It is strictly forbidden to operate a boat in a state of alcohol, drugs or other intoxication.
    3. It is strictly forbidden to use the boat without individual life-saving equipment (life jackets or life jackets, belts, circles, etc.). Attention! Pay special attention to the choice of life jacket. It must be equipped with a label containing the load capacity and have a safety certificate.
    4. If your boat model is equipped with an engine, it is strictly forbidden to approach swimmers in the water at speed. Do not allow swimmers to approach the stern of your boat while it is moving.
       FORBIDDEN !!!
    • Use a source of compressed air (auto-compressor) to pump the boats.
    • Load the boat above the set maximum capacity.
    • Use an outboard motor with a capacity exceeding the maximum allowable.
    • Bring the pressure in the cylinders to a mark exceeding 0.3 kgf / cm 2.
    • Do not drag the catamaran on a hard surface (asphalt, stones, broken glass, etc.).
    • Pull the catamaran by the front pipe, which is installed in the stall, and the safety leer.
    • Pull the catamaran by the carrying handles and the duck handles alone. Each handle has its own load capacity (carrying handle - no more than 25 kg, duck handle - no more than 50 kg).
    • Install high-power motors on a regular transom.
    • Make additional holes in the transom or frames without the consent of the manufacturer.
       Recommendations:
    • Before entering the water, make sure that all equipment, including oars, pump, life jackets, are on board the boat.
    • The weight should be evenly distributed along the length of the boat. If the equipped boat is overloaded, there may be problems with the water supply through the drain valves and its control. Always tell someone about the time and place of departure, future route and time of return.
    • For long-distance sailing routes, you need to take a flashlight, first aid kit, anchor, insurance sloth on board.
    • Beware of winds and currents directed from the shore.
    • If one of the air chambers is damaged, move the load to the opposite side. Whenever possible, secure the damaged camera (by tying it or holding it in a suspended position).
       Warranty service
     
    1. The warranty will take effect after the date of sale and the seal of the seller in the warranty card. The warranty will apply in the cases described below.
    • The case material is included in warranty service for full 3 years in case of emergence of cracks, porosity and rotting.
    • The seams of the case are included in warranty service in case of stratification within 3 years.
       NOTE. Seams are considered to be layered when the outer layer separates from the woven base or the seam loses its structural strength. The boat is considered high quality while maintaining 80% of the volume for 12 hours in the inflated state.
    • In case of using the boat for commercial purposes, warranty service - 1 year.
    • All other components of the boat, including valves, cochets, oars, pump, towing rings, decking elements and seats are covered by the warranty for 12 months for all boat models.
    2. As this warranty applies only to defects in material or workmanship, it does not cover normal wear and tear and abrasions or damage caused by:
    1. negligence, lack of maintenance, accidents and improper operation of the boat;
    2. using an auxiliary device or component not manufactured or sold by us;
    3. change or delete a component.
    3. Warranty service does not include the cost of accidents or their consequences for incidents such as towing, launching, towing and storage, telephone or rental of any type of boat, inconvenience, time or damage due to any damage.
    4. The buyer must provide access to the product for warranty service, deliver the product for inspection to the production located in Kharkiv (at its own expense), which will repair the product. Inspection and repair will be provided if such maintenance is included in this warranty. If during the inspection it is established that the repair is not included in the warranty service, all costs are paid by the buyer.
    Every product or component provided by the buyer for inspection or repair must be washed and dried. 
    5. Our warranties under this warranty will be limited to the repair of the defective component or the replacement of such component or components as will be necessary to remedy the defects caused by defects in material or workmanship as specified in the warranty.
    We reserve the right to change the design of the product without undertaking to change the previously manufactured product. 
    The boat was built under the supervision of the Inspectorate of the Register of Shipping of Ukraine. 
    Certificate of the Register of Shipping of Ukraine № SVP -224-3-39-18
     
     
    WARRANTY COUPON
     Owner______________________________________________________            
    Model________________________________________________________
    Sequence number_______________________________________________            
    Year of manufacture__________________
    Date of sale_____________________
    p.p. 
     
    Familiar with the operation manual and warranty obligations                                                                                                                                    
     
    Owner's signature _______________________
     
    Warranty repair №1 __________________________________________________________________________________________
    ___________________________________________________________________________________________________________
     
    Warranty repair № 2 _________________________________________________________________________________________
    __________________________________________________________________________________________________________